WOODBRIDGE 71" Whirlpool Water Jetted and Air Bubble Freestanding Bathtub-BTS1611/B0034

A: 1)Yes it is possible for you to connect both motors to a 20 amp circuit.  2)I believe the amp is 2.50 for on each.  

A: Unfortunately the lights do not adjust to one color if Jets are on the lights will be changing colors the whole time

A: we don't unfortunately   all of our bathtub including air bubble and air jetts are doubled wall and holds the heat for about 20 to 30 min

A: Both GFCI breakers be on the same 15 Amp household circuit is fine.

A: So sorry you are having an issue with the jets not working. I found your order along with the exact model and generation you have. There are a couple things you will want to look into. First It is unlikely the pump or air mover would become defective as they are very powerful and are under worked for their capabilities. The first thing to check would be the breaker or the GFCI outlet to make sure power is available. You can do this simply by plugging another appliance into that same outlet to test. If all is good there, then the next thing to check would be the air-lines that connect the pumps to the control buttons. It is very uncommon, but during shipping or installation it is possible that one of these lines was pulled on and was barely hanging on and now has come loose. These buttons aren't digital and there are no circuit boards or complex electrical components. They are in fact physical and when depressed they just push a small amount of air through a clear rubber line to move an actuator and turn the motor on. If this turns out to be the issue it is fixable and doesn’t require any extra parts or special tools. You need only turn the tub on its side and locate which line isn't connected to the bottom of the button and re-attach by pushing and twisting back onto the plastic barb underneath the button. Then test the functionality and you will be done. Since it may be hard to tell if the line is all the way on you can apply a small amount of blue PVC cement to the hollow barb using a Q-Tip, making sure to not block the hole, and that will melt the two pieces together and ensure that even if you don’t get it on well it will still hold forever. These steps will determine if the motor went bad. If that ends up being the case we can address a replacement. I will attach images to assist you in locating these lines and where to attach. If you or your plumber have any questions please feel free to call and we will walk you through it. Also, if you discover that the buttons are not the problem have him take pictures of the lines connected underneath so we can officially rule that out.

A: Yes you may use any faucet of your choosing since the faucet and the bathtub are not connected. You may use bath bombs, it is just recommended to clean out the bathtub after the use of them so the residue does stick to the jets Depending on where you are located normal lead time id between 7-12 days 

A: The filler is just shown for aesthetic purposes. Unless stated otherwise the tub filler does not come with the bathtubs.

A: Yes all those products are safe to use, just be sure to clean out left over residue from product, which can cause build up if left un treated.